Custom fixtures parameters settings weird intensity functional

Hi Guys,

Any  replies on this post to allow me setup these Chinese not referred  fixtures.

Thanks 

Oumar

Dear Oumar,

it is quite hard to help you without testing with the unit itself.

And the Ranges in your Intensity are nice to have a look at.

The Fixture is quite something different : )

What jumped to my eye was the Pan and Tilt. They most likely are 16bit.

You can change that by clicking at there DMX-Addr. in the DMX coloumn.

And the Movementspeed is set up Virtual in your Fixture. In the Manual, it is DMX Ch5.

yours

thilda

Dear Thilda

thanks for your response i already tried 16 and 8 bits in the pan and tilt , The issue here is the intensity in DMX channel 6 of the fixture that had range as per the manual and i cannot set it right ..

The behaviour of the intensity is weird when i am @ out the light is on and when @full its a strobe...

regards,

Oumar

Dear Oumar,

without any test option on a real fixture, here is a testfile for you.

Please hop in and give it a try.

Chinese Mini Wash 2022-04-18 02-31-31.esf3d

I only was able to hook up my Console to a DMX - Tester to confirm that your DMX-Table is correctly outputting.

The Table is a little bit confusing with the Colors... But i added 256 Colors.

Hope it will work out for you.

Yours

thilda

Dear Thilda ,

You are a Rock star , It work like a charm, Now i analyze what you had done , i realize that the conditions that was missing is to put mode on the ranges as per the below screenshot, Please  advise how you had done it.

Thanks.

Oumar

Dear Oumar,

great to read that it works.

The "great magic" is at the end of the list.

The virtual parameters are helping to define the Modes, which later can be assigned to your Paramters with the DMX Values.

Can be seen here:

Choosing a good name for the virtuel parameter is sometime realy difficult for me ; )

You can than create 'New Modes' in you DMX-Parameter

And assign the virtuel Parameter, now working as a Mode-value, to it.

I learned a lot from looking into Fixtures from the EOS library.

If you are interessted and need this more often, keep digging.

But on your regular bases, i think you don't need to create Fixture.

But it is quite interessting nerdy stuff : )

Have a great day.

yours

thilda