Is there a way to flexi to channels active in a certain cue list

you can create 2 partitions, 1 with chs from QL1, other one with chs from QL 2; give one partition per Qlist (in Ql tab), then tell your live flexi tab to use partition (when in the live tab, keep FORMAT and press partition). Then, if you call QL1 or 2, you'll see only ch. from QL1 or 2. That's how i do. I created macros to jump from 1 partition to another one.

You'll see only ch from QL1 when QL1 is selected.But you won't be able to see them distincts in 2 live tabs same time, if that's what you hoped.

The same channels are in all cue lists, just at different times. So this wouldn't work for me.

can't you get partition 1 for all channels and part 11 for followspots? in which case, in one QL you'd see all of them, and in another QL you'd see just followspots?

Effectively every light in the  show can be both a desk channel and a follow spot. I'm effectively trying to create a separate live table for "these lights are follow spots" and another live table for "these lights are not follow spots". But which lights should be in either bucket changes on a cue by cue basis.

indeed, seems complicate if all lights can be one or another one. i really don't see how eos could make a difference between a ch used as a followspot and same ch used as desk ch.

It's just a param. The profile has a control address that the remote follow spot system listens for, and when active, takes control and supercedes the pan/tilt values from the desk.

Choosing to place the lights in a separate list that way is just an organizational decision.

unless, maybe:

configure 2 Live ch tabs partitionned. Record FP or PST desk from1 thru 500 and FP followspots from 501 thru 600

create a macro X:

partition 11 enter

group FP 501 thru 600 enter enter

partition 1 enter

group FP 1 thru 500 enter enter

make for every cue "execute macro X"

Can't try it now, but i guess for every cue, your 2 ch tabs should evolve regarding who's in FL 1T500 and who's in FL 501T600

Rather than doing partitions, I would just tab into the appropriate table and change the viewed channels to match the query.

Very kludgy, but yes, maybe doable that way.

if you don't make partitions, can't see how you hope to see only desk or only follow. If with Live table active, you won't be able to work inside without loosing your selection

You can set live table to "view channels" and lock the tab to always view the same channels.

but my syntax is not good, partition 1 would bring partition 1 active, but would not acces setup to change partition chs

You can macrotize group # or select last "View Channels" and it will put the selected channels as the locked channels for the current table. If you combine this with some Tab down 1.1 Tab up select last view channels, you can rotate through all the open tables and set whatever channels you want to be viewed in them.

i don't get it. if you select last or group#, then you have to correct one of the ch, once you select it, won't you loose the view you wanted.? (plus, sorry, i'm french, trying hard to get everything but sometimes don't succed)

View Channels is a Flexi Mode. See here in the manual.

anyway, my solution was a bad one: this would still make only one partition per time, but won't allow you to get 2 different partitions in 2 tabs live ch same time, you'd still have to jump from one partition to another one. But this gave me to think, at least i tried ;-)

i might not speak english fluently, but i know what flexi mode is for a long time now ;-)

sorry, really misunderstood yesterday night, guess working too late is'nt so productive...

sorry, really misunderstood yesterday night, guess working too late is'nt so productive...