Auto-mark function on ETC software nomad

You seem to be using the Element version of ETCnomad. For Element Auto-Mark is always enabled and because of that no setup setting is needed.

As soon as you change your Nomad to use the Eos mode you will get the Auto-Mark setting back.

Thank you very much for your prompt answer. I appreciate your help. 

I have tried to do what you suggested me, but unfortunately is still not working.... I have read some similar solution on the manual, the point is: that the option of " default enable auto-mark" as it should be, simply doesn't comes up. the function auto-mark is disabled and I  cannot do anything about it: (E.g. I pick a moving light and I put it on a certain position on the singer on stage and when I playback the sequence it makes that live movement of positioning anyway). According from what has been declared also, There are those "M" of Mark that they should be by default showed on every cue of the psd tab, but actually there aren't any and when I tried to click on them on the M column, nothing happens. any suggest to change the status of auto-mark off in "on"?  

cheeers thank you for your patience 

So you're not in Element mode anymore but setup still doesn't show the Auto-Mark setting?

What software version are you using? And can you send the showfile to eos(dot)moderator(at)etcconnect(dot)com?

I am using Element 2 nomad Eos, I selected: offline mode with visualizer, (capture). Version 3.0.0

Thank I am sending back to you right now my show-file

Thank you for your showfile.

As long as you are using Element mode, you will have no choice. Auto-Mark is always on, that's why there is no setting in setup.

In your showfile there is only one oppertunity for Auto-Mark and that would be doing the marking in cue 1 to prepare for cue 2. You have however added an Auto-Mark Off flag to cue 2 so there is no marking happening in preparation of cue 2.

If you get rid of the Auto-Mark Off flag in Cue 2 you will see e.g. channel 30 mark in cue 1. To get rid of that flag: Cue 2 {AutoMark Off} Enter

In which other cue and for which channel were you hoping for Auto-Mark?

You've been very supportive towards me, thank you very much! I will have a try. I think I will come up with a nice solution after following carefully your reply 

Oh sorry there was question at the very end of your explanation.... I wanted to have the spot-light directly turned-on on the singe, so, that is meant to be set and placed between cue 0 and cue 0.5 but as it might gets harder because 0 is a particular number, on my own I am trying to make a 0.1. to start with before 0.5....Does it sounds about right to you ? Chheeeeers