ETC NOMAD - Working fixtures

Thank you for reaching out.

Without seeing the two fixture profiles you created yourself I can't tell you what went wrong. You can send us a showfile to eos(dot)moderator(at)etcconnect(dot)com.

Regarding the Odeum:

• Cooling Fan: That's the fan to keep the fixture cool, this can't be visualised.
• ColorMix: The profile lacks information which color the fixture shows when you choose e.g. Color 1. You can add this if you change the parameter name to Color Select which allows to create a color wheel and then add it to the channel.
• Color Temperature currently isn't visualised in Augment3d.

Thank you for the reply.

All my fixtures work in the pysical world, only on augmented 3D this doesn´t happen.

But after reading your post i understand there is a lack of information for the fixtures. They don´t know what gobos or colors existe so they can´t work proprely, when i create a new fixture i have to input the information, right? If so, how can i do it? I´ve been searching in ETC youtube channel, on the augmented 3D playlist, but there is no information on this kind of problem.

Thank you

Following this post:

 RE: Creating Gobo Wheels for for Augment3D Moving Lights 

I did this and config the color selector and gobo selector, but still not working, what i´m i missing here?

This is quite hard to diagnose without your showfile. You might have created the gobo wheel but not assigned it to the channel? In Patch > Attributes select your channel, on the right you should see Gobo_Select, click it and choose the gobo wheel you created before. same for Color_Select.

This all requires a fixture profile that has used the parameter names Gobo_Select and Color_Select.

This is quite hard to diagnose without your showfile. You might have created the gobo wheel but not assigned it to the channel? In Patch > Attributes select your channel, on the right you should see Gobo_Select, click it and choose the gobo wheel you created before. same for Color_Select.

This all requires a fixture profile that has used the parameter names Gobo_Select and Color_Select.

Greetings,

Last week i sent the showfile for diagnose but didn´t have any reply since Feb 25

Best Regards

Sorry for not getting back to you.

This is the solution for the Varytec's strobe:

This showfile has a better version of Weinas (and the fix for Varytec).

The DMX sheet for Weinas is missing information how to switch from indexed gobo to rotating gobo. Unless the gobos are always in rotation mode... But at least Augment3d now correctly shows the gobos and colors.

Cine Teatro Testing 2025-03-07 13-28-15.esf

Thank you! Already tested and its working fine!