Multi console (primary + client) version 3.3.0

If you also have a wifi connection, try to toggle multi-console on that network connection. It shouldn't matter, but it does.

I have connected by the control port (NIC 1) with both consoles. There is a wifi connected to that network we use for remote focusing. The other NIC sends sACN to the LX network. I have followed the trouble shooting article provided by ETC but have still come up empty handed. We have now packed away the 2nd console so it will ne a little while till I can get back to this.

regards

Geoff

I've had the same situation, but I forgot to write up the solution. I am also not in the situation to test this anymore, but at the time it occurred to me as a bug, especially since the two consoles saw each other in the software, but would not connect until I did toggle this selection box (which makes no sense).

My set-up:

Apex console as Primary

NIC 1: sACN to rig

NIC 2: Connection to Client and OSC from CueLab, Stamp and Capture

Laptop:

NIC 1: Connection to Main Console as Client with Eos Nomad dongle, Stamp (OSC) and Capture (Net3/sACN)

NIC 2 (Wifi): Used for Internet connection

I've had the same situation, but I forgot to write up the solution. I am also not in the situation to test this anymore, but at the time it occurred to me as a bug, especially since the two consoles saw each other in the software, but would not connect until I did toggle this selection box (which makes no sense).

My set-up:

Apex console as Primary

NIC 1: sACN to rig

NIC 2: Connection to Client and OSC from CueLab, Stamp and Capture

Laptop:

NIC 1: Connection to Main Console as Client with Eos Nomad dongle, Stamp (OSC) and Capture (Net3/sACN)

NIC 2 (Wifi): Used for Internet connection