iRFR channel check mode??? for iPhone app

The RFR will now boot into channel check mode - this was changed in 1.9.5.  To get to live mode, hold down the upper left button and select "live" on the appropriate softkey.

-Todd

I for one, wish it would boot into LIVE mode instead of channel check mode.  There doesn't seem to be a sneak or out option when in channel check mode, so I keep mistakingly bring up a channel manually and have to switch to LIVE mode to take it out.

In my original reply, I missed the "i" part in "iRFR"- so I described the behavior of the dedicated RFR unit.  I'm not sure if the iRFR does the same thing...

JP- on the RFR in channel check mode, pressing [clear] should take out the channel as well as clearing the command line.  If it doesn't then there's something strange happening.

-Todd

I realized that it was a small "i" so I edited.  But anyway thanks for the quick reply.

I realized that it was a small "i" so I edited.  But anyway thanks for the quick reply.

Todd, yes clear works when in actual channel check mode, but if you actually type in "1atFULL ENTER" it captures that channel at full.  The only way to take it out is either to set it at 0 or switch to LIVE mode and sneak or out it.

jpgagnon said:

Todd, yes clear works when in actual channel check mode, but if you actually type in "1atFULL ENTER" it captures that channel at full.  The only way to take it out is either to set it at 0 or switch to LIVE mode and sneak or out it.

JP- on my RFR if I type "1 @ FULL ENTER" in channel check mode the RFR command line reads:

• 1 @ FULL CHECK *

If I press CLEAR, the command line is cleared and the channel goes out.

I would give ETC a call- perhaps its a RFR firmware or configuration issue.

-Todd

My apologies about my previous statement about 1@FULL ENTER.  Yes, that puts it into channel check, but if you type 1 FULL FULL(which is much quicker) it does not add the CHAN CHECK at the end of the command, so then that channel is captured(sorry, old expression term) and the only way to un-capture it is to switch to LIVE MODE and OUT or SNEAK it.  I would like an option on the chan check page for a softkey for OUT or SNEAK.  Or of course, just default to LIVE MODE (I like the idea of a preference for this default).

Thanks all for your input  JP, we agree with both of your comments.  

:-)

a