Ion : LTP mode when using a sub master while not programed as LTP ....

Hi,

I'm not sure if this is the behaviour you're experiencing when you say LTP, but if when you move the fader from zero the values jump to the levels of the Submaster, it may be that it is set as Independent.

Check the Priority column in the Submasters editor display, if this says Independent this may be what's causing your problem.

Cheers

Dan

Dear Dan,

I checked everything in the Submasters displays yet, nothing is programmed as independent or priority or anything else that's why i really don't understand ! 

Thank you for your answer

Riri

Hi Riri,

Sorry this hasn't helped with your problem. Can you be more specific about what is actually happening. Can you give some steps and tell me what results you are getting?

Thanks

Dan

You can use your wings in channel mode.  If you hold down fader controls as you would to change pages on the wings, you will see a selection at the end of the page options to put them into channel mode.  It is pretty apparent when you are in this mode - the LEDs are red and the display indicates channel.

If you'd care to post your show file here, and explain exactly which channels/submasters etc you are seeing this on, I'm sure several of us would be happy to take a look!

Thanks much!

a

Hey Dan, 

I'll try to be more specific about what is happening. 

- I open my show, everything is loaded perfectly, and all the sub masters i recorded on the element are working good as well as the cues, part cues, time ..... Nothing wrong.

- I want to create a new sub master, i do my preparation ex :  channel 24+channel 23@Full record sub 12 , the green led under the fader is lighting...

-I go check on the sub display, everything is normal, by default, no independent, or ltp or anything else ...

-I have a cue sent live on stage, and i want to add my sub master n°12, when i up the fader the cue on stage is desapearing, like if my sub master was programed as LTP mode. 

Thank you very much

Hey Dan, 

I'll try to be more specific about what is happening. 

- I open my show, everything is loaded perfectly, and all the sub masters i recorded on the element are working good as well as the cues, part cues, time ..... Nothing wrong.

- I want to create a new sub master, i do my preparation ex :  channel 24+channel 23@Full record sub 12 , the green led under the fader is lighting...

-I go check on the sub display, everything is normal, by default, no independent, or ltp or anything else ...

-I have a cue sent live on stage, and i want to add my sub master n°12, when i up the fader the cue on stage is desapearing, like if my sub master was programed as LTP mode. 

Thank you very much