Questionss!

Hi Anthony,

The switch between RGBHV input and the SDI coming through the graphics engine is a 5-8 second switch that requires closing the iris to enact the switch.

As you pointed, out, the only way to keystone when using the RGBHV input is with the projector itself, of which there is no control over through DMX/Artnet. So, if you did set your keystoning using the projector remote, when you switched from your first cue to your second cue, the projector keystoning would still be active, plus whatever keystoning you did through the graphics engine on the SDI. While it might be possible for it all to work, there's a good chance you will be cutting off a large amount of your projection size.

Let me know if you have any more question.

Thanks,

Hi Matt,

So the best way would be that every content is loaded on the HDD or runned thru the SDI.

Thanks

I would suggest adding Axons to the "stationary" projectors. Then all projectors will program exactly the same from the console (minus MOTION for the Axons). Deploy the content across the network and do everything from the console.

My personal opinion....

Any idea why Server Blue LED and Hard Drive LED wont show up? 4 dl.3 running perfect but there is one without those led on BUT it is still working perfectly... any advice?

Anthony

Hi Anthony,

They're probably just unplugged from the computer motherboard. Those LEDs can be traced back to the computer and actually plug in right near the computer chassis fan. Just double check that they're fully seated and have the correct polarity (they should be labeled and plug into a white header that directly connects to the motherboard).

Thanks you Zach!

Hi!

Any Idea why I Can't output SDI? Normaly you have to put Media Folder to 255 and File to 2 right? + click on motion and select Fixture to SDI capture Right?

I'm using an Analog way UltraVio with an SDI output, We are currently using a Laptop connected to the UltraVio by VGA, im outputing SDI 480I and receiving from the VGA input signal from the computer.

Do I miss something?

Anthony

Anthony,

Are you trying to output the camera via SDI? If so you need to set your Motion's Intensity to 0, then choose Camera to SDI, wait about 5 seconds, and then bring Intensity back to Full. This should then be sending this units camera feed out via SDI to your other source.

The steps you listed would be to capture SDI, not output SDI. But either way don't forget that in order to change the SDI and S-Video routing you have to set Motion to 0 for a few seconds and then send the command while at 0.

Zach,

Im trying to output lets say a Laptop via an Image pro, im trying to get an external sdi feed in the dl.3.

Ok. Then your steps are correct, just make sure to have Motion at 0 when setting Capture to SDI. Also make sure you have set it to either PAL or NTSC (this was implemented in v1.5.0 however the current version is 1.5.2).