• Date
    marlonpagaran
  • Date
  • Replies 2 replies
  • Subscribers 67 subscribers
  • Views 57 views
  • Users 0 members are here

CEM+ version 3.1.3.9.0.44 error display

Hello,

Does anyone know why is it with the latest CEM+ version 3.1.3.9.0.44 has error message on display says to update version? Another rack with older version 2.1.0.9.0.24 has no error message. Thank you.

Parents

  • Yes, this is something that can happen. It’s not uncommon for one rack to report a version mismatch while another does not. There are a few different reasons why this might occur depending on how the system is networked and how the racks were updated.

    A few quick questions to help narrow it down:

    • How many total racks do you have?
    • Are they all connected to each other?
    • Are they all on the same network?
    • Is your overall system operating normally despite the version mismatch error on the 3.x CEM+?

    If everything is functioning as expected, this is likely just an annoyance rather than a critical issue.

    When you’re ready to resolve it, you can update the older 2.x CEM+ to match the newer version. This ETC Support article walks through the process step-by-step:
    How to update software on a CEM+ module

    And of course, if you’d prefer direct assistance, ETC Technical Services is available at 800‑688‑4116.

  • in reply to mmeskill
    • How many total racks do you have? - 4 racks
    • Are they all connected to each other? - Yes! 2 dimmer room location(2x racks each room) locations link thru media converter (fiber to Rj45) 
    • Are they all on the same network? Yes!
    • Is your overall system operating normally despite the version mismatch error on the 3.x CEM+? yes all working. But one of the rack with error (update software) which is already current version and freezes sometimes. 

    How to clear the error? Thank you.

Reply
  • in reply to mmeskill
    • How many total racks do you have? - 4 racks
    • Are they all connected to each other? - Yes! 2 dimmer room location(2x racks each room) locations link thru media converter (fiber to Rj45) 
    • Are they all on the same network? Yes!
    • Is your overall system operating normally despite the version mismatch error on the 3.x CEM+? yes all working. But one of the rack with error (update software) which is already current version and freezes sometimes. 

    How to clear the error? Thank you.

Children
No Data
Related

www.etcconnect.com