Venue Thinpar 64 & ColorDash Fixtures

A quick look at the manual indicates that it is very close to the existing "PAR 38" in the library. So, you could patch it as Generic RGB LED 8B and run it in 3-channel mode, or copy and edit the PAR 38 personality to add a dimmer channel (and possibly some other small changes) and run it in 7-channel mode.

Because the Eos/Gio/Ion software has a lot of control over colour/intensity, etcetera - you probably won't find much advantage in the 7-channel mode, to be honest.

Luke

A quick look at the manual indicates that it is very close to the existing "PAR 38" in the library. So, you could patch it as Generic RGB LED 8B and run it in 3-channel mode, or copy and edit the PAR 38 personality to add a dimmer channel (and possibly some other small changes) and run it in 7-channel mode.

Because the Eos/Gio/Ion software has a lot of control over colour/intensity, etcetera - you probably won't find much advantage in the 7-channel mode, to be honest.

Luke

Thanks!  That worked like a charm.  I assume I can use the same generic profile for the Venue Thinpar too?  I am going to try it tomorrow (I don't have the right DMX cable for the ficxture).

I can't seem to get the Venue Thinpar to patch and work.  I tried pretty much all the generic RGB fixtures.  Can someone point me in the right direction, I am beyond frustrated and tired of this.  Thanks.

One more headache, the fixtures work great when I have them plugged into my FOH chauvet datastream.  Once I take them to my datastream on the stage they don't work.  Can someone tell me what I might be missing?

have you tried creating a fixture using fixture editor?

I mean our DMX splitter.  I thout about the universe thing too, but I have some chauvet colorstrips running off the on stage DMX splitter that work just fine.  They are on universe 1 (address is 200) so I am not sure what the issue is.

I realized that it is not the profile since it works FOH but not on stage.

Not that it matters but the colorstrips are on channel 200, I'm not sure what their address is.

try first principle. check Cables and connections  might be just a bad cable on stage  

Thanks, I tried at least 5 cables as well as the know good cable from my working colorstrips.

Did the cable option Work?

No, it's not the cable.  The known good one didn't worth either.  I am thinking it might be a universe thing.

if its not cables, then its either a universe or addressing issue. remember that patching fixtures on each universe above the first one, need to be written 2/DMX Address, 3/DMX address and so on. Or second universe starts at 513 to 1024. 3rd universe starts at 1025. if your address of your fixtures are starting at 200, and they are on a second universe then you need to patch as 2/200 and so on.

So back to cables.....is the stage locations wired to a  second universe.

Thanks for the suggestions.  I am not on site today, but now that I think about it, I mounted a couple big movers a month ago and they are on universe 2.  They worked perfectly and they are using the DMX splitter on stage.

my question is, the fixtures I am trying to add say they are only addressable up to 512.  If they need to be on universe 2, how can that work?

You can live at 171 Main St. and somebody else can live at 171 Oak St. and the mail still gets to both houses even though they share the same address (171). The universe (1 or 2) is the street name.