gadget only outputting up to address 60

Hi There - I'm having this same issue currently on a mac running 10.12  and the 2.7.4 EOS Nomad software with a Gadget 2 (brand new) - has there been a solve for this?

Thanks in advance,

Blair.

Hello, Blair:
This issue was resolved back in v2.6.0, so it is possible you might be experiencing something different.  Can you clear your command line and press [About], please (y on a qwerty keyboard)?  It should show you "Allowed Output Addresses."  Is this limited to 1-60?

Thank you,

Sasha

Hello, Blair:
This issue was resolved back in v2.6.0, so it is possible you might be experiencing something different.  Can you clear your command line and press [About], please (y on a qwerty keyboard)?  It should show you "Allowed Output Addresses."  Is this limited to 1-60?

Thank you,

Sasha

Hi sasha, screenshots attached. It works fine when using my node over sACN, but not using the gadget 2...About page looks fine to me also, says 512 addresses...

Could you tell us the firmware version on the Gadget (look in Tab 99 / Diagnostics)?  And could you clarify if the output tops out at 60 on both ports 1 and 2, or just 1? 

Also, if you save your current show, then do a deep clear, then in a new show, patch Channel 1 at 1 and Channel 2 at 61 (or some higher address that should work) - do you get output then?

Hi Matt - Apologies, haven't been near my console the last few days.

The issue happens on both ports. And I've tried it on two different Gadget II's - one running 1.1.1.5 and the other on 1.1.0.4. It's the same on both ports on both of them. OS is Mac OS 10.12.6

I've done a deep clear and tried making a new show. It still has the issue.

Any other thoughts?

Cheers,

Blair.

Hi Matt - I've just set this up with another mac running a fresh install of 2.7.4 and OS X 10.14 and it works fine with the gadget running 1.1.0.4, however the one running 1.1.1.5 refuses to acknowledge that its connected on the diagnostic screen...